Epoxy Powder
Coatings
Epoxy
powder coating is recommended
for use in interior situations where toughness,
chemical resistance, and good mechanical resistance
properties are essential. The protective
properties of epoxy powder coatings are not impaired
by exterior exposure, but chalking will occur progressively.
Properties
| Mandrel bend |
BS3900 E1 |
Pass 6mm |
| Scratch |
BS3900 E2 |
Pass 4kg |
| Impact |
ASTM D2794 |
Pass 20-100 in lbs. depending on formula |
| Adhesion |
BS3900 E6 |
No detachment |
| Humidity |
BS3900 F2 |
Pass 1000 hrs: no blistering |
| Salt Fog |
ASTM B117 |
Max. 2mm creep @ 500 hrs |
Typical applications include:
- Laboratory fittings and fixtures
- Machine Tools
- Indoor Sports and Recreational Equipment
 Antique
Finishes Suitable
for interior use, these highly attractive hammer
type finishes offer a tough patterned coating
normally chosen for aesthetic value, but capable
of disguising substrate imperfections. Available
in:
Nap-Gard® Fusion
Bonded Epoxy Powders Nap-Gard® Fusion
Bonded Epoxy Powders from Dupont are designed
to coat oil & gas
distribution pipelines & reinforcing steel
rebar to provide maximum corrosion protection.
In addition, they exhibit excellent hardness
and abrasion resistance as well as coping admirably
with the often difficult site conditions encountered
by providing an excellent resistance to direct
impact & backfilling.
Vanguard® Vanguard® from
Dupont is a high performance fusion bond epoxy
designed to
give excellent corrosion protection to steel & cast
iron valves, pipes & fittings. Most importantly,
it is Potable Water Approved, (BS6920). This is
a single coat treatment that can be applied to
shot blasted metal. No pre-treatment
or primer is required.
|
